![]() Using concrete and masonry stain to improve the look of your tired old concrete surfaces really is an easy project that anyone can handle. If removal of stain is required, stain can be removed after curing with a stripper, grinder, or sand blasting. ![]() Routine cleaning and resealing will help extend the life and appearance of stained surfaces. Then, fill the cracks in with a concrete patching compound. Allow 24-48 hours for stain to cure before exposing to rain. First, sweep any loose concrete or or other debris that may be in the crack or the surrounding area. Dampening the surface prior to applying stain will help hide brush or roller marks. Applying in direct sunlight or on hot surfaces can cause rapid curing. Do not apply stains in temperatures above 100 degrees F or below 45 degrees F. When applied by experienced professionals, concrete stains combined with the realistic. Concrete should be minimum of 7 days old for Silica Shield and 3 days old for CAM Stain, but the longer water has to leave the new concrete the better. Staining and sealing allow for customization of any of our products. Practice applying the colors for your desired look on an inconspicuous area or on a cement board. Stain can be applied with a brush, roller, sponge, or sprayer. Scrub surface with a broom or brush and remove with a solution of baking soda to neutralize the surface. Dense concrete will require a strong solution while porous concrete will need a diluted solution. An Etching Cleaner is recommended to open the pores of the concrete and to clean the surface. Dirt, oil, grease, bond breaker, sealer, and paints will hinder the preparation and bonding of the stain, therefore these must be removed from the concrete before application of stain. ![]() Proper surface preparation is the most important thing to ensuring the successful application of a stain. It is recommended for use on driveways and other areas of high traffic due to the fact that is provides a great hot tire resistance than the CAM Stain. Silica Shield penetrate the concrete to make chemical bond with concrete, this is why it is NOT good to use on an area that has been previously sealed. Silica Shield is a water based, modified silicate stain that provides a highly transparent appearance. The concrete stain has no effect on the structural stability of cinder blocks it only colors them to give them a distinctive mottled appearance. It is not ideal for driveway applications as it does not have as good of a hot tire resistance as the Silica Shield. Can You Use Concrete Stain On Cinder Blocks Yes, the concrete stain can be used on cinder blocks. CAM Stain is ideal for staining an area that may have been previously sealed. CAM Stain (Concrete and Masonry Stain) is a semi-transparent, water based modified acrylic that is easily applied with fewer restrictions than the Silica Shield.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |